11/7/2023 0 Comments Alt-Tab Terminator 6.0 instal![]() Additionally, the last device in the daisy chain must be terminated with an active terminator. Practically, it may not be possible to connect more than three external devices because of this cable limitation. You are finished installing the floptical or second hard disk drive.Ĭaution: You can connect a maximum of five external, single-ended SCSI devices to the standard 50-pin connector on the back of the Challenge S server if the maximum combined cable length of all external SCSI cables does not exceed two meters. Then restart the system and check the drive installation with hinv again. To check, power off the system and check the power and SCSI connections and ID. If it doesn't, it may not be properly connected and configured. Make sure the drive appears in the hinv listing. If you have more than one hard disk drive, you'll see multiple disk drive listings, each with a different controller unit number combination. Integral SCSI controller 0: Version WD33C93B, revision Dĭisk drive: /removable media: unit 2 on SCSI controller 0 Integral SCSI controller 4: Version WD33C95A, differential, revision 0 Integral SCSI controller 5: Version WD33C95A, differential, revision 0 Integral ISDN: Basic Rate Interface unit 0, revision 1.0 Secondary unified instruction/data cache size: 1 Mbyte The hinv command provides a list that looks similar to the following:įPU: MIPS R4010 Floating Point Chip Revision: 0.0ĬPU: MIPS R4400 Processor Chip Revision: 6.0 At the System Maintenance menu, select option 5 to enter the Command Monitor.Īt the Command Monitor prompt ( >), enter the following command: hinv
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |